Stackable cases

MDF and methacrylate stackable cases for store and display your miniatures.

Available options:
    ● Useful height: 5, 7, 9, 11, 13, 15, 17, 19, 21, 23, 25cm
    ● Front material: MDF, Methacrylate
    ● Fixing material: None, Magnetic sheets (0.9mm thickness), Steel sheets (0.2mm thickness)

Outside dimensions:
    ● Width: 26.2cm
    ● Depth: 29.9cm
    ● Height: 0.8cm more than the chosen useful height

The stackable cases have a useful area of 25.6cm wide by 29.0cm deep and are fully compatible with both the inserts of the horizontal cases ant the shelves of the vertical ones.

The cases are stackable with each other and are designed to get closed with either an upper cover or a horizontal case, which are also designed to fit on top of one of these stackable cases.

The magnetic sheet has a holding force of approximately 40g/cm2, enough to hold upside down almost any miniature with a steel sheet on its base or vice versa. In case of having neodymium magnets on the base of your miniatures, it will be necessary to choose the steel sheets as the fixing material.

The case is supplied unassembled (assembly instructions included). The steel and magnetic sheets are supplied cut to the corresponding size and not glued. Magnetic sheets have only one side magnetised. Assembly requires the use of contact or instant glue. The upper cover is not included.

The methacrylate of this product is highly transparent and has a very good scratch-resistant surface quality. The MDF of this product meets the requirements of Class E1 (low formaldehyde emissions) as defined by the European Standard EN 622-1:2003.