All best sellers
Caja horizontal con puerta y frontal de metacrilato
  • Caja horizontal con puerta y frontal de metacrilato
  • Caja horizontal sin material de fijación
  • Caja horizontal con insertos y lámina magnética
  • Caja horizontal con miniaturas de 15mm y frontal de metacrilato
  • Caja horizontal con miniaturas de 15mm y frontal y puerta de metacrilato
  • Caja horizontal con miniaturas de 15mm y puerta de metacrilato desde el frontal
  • Caja horizontal compatible con las baldas
  • Cajas horizontales apiladas de los dos tipos
  • Cajas horizontales apiladas de los dos tipos

Display cases

CMH-050-220
MKZ Games
MDF and methacrylate display cases for store and display miniatures.
Height
Front
Door
Fixing material
€25.95
VAT included
Quantity

Description
MDF and methacrylate display cases for store and, display miniatures.

Available options:
    ● Useful height: 5, 7, 9, 11, 13, 15, 17, 19, 21, 23, 25cm
    ● Door material: MDF, Methacrylate
    ● Front material: MDF, Methacrylate
    ● Fixing material: None, Magnetic sheets (0.9mm thickness), Steel sheets (0.2mm thickness)

Outside dimensions:
    ● Width: 26.2cm
    ● Depth: 29.9cm
    ● Height: 1.4cm more than the chosen useful height

The horizontal cases have a useful area of 25.6cm wide by 29.0cm deep and are fully compatible with both the inserts of the horizontal cases ant the shelves of the vertical ones.

This horizontal case can be stacked on top of a stackable case instead of the upper cover. The door opens by sliding out horizontally along side rails.

The magnetic sheet has a holding force of approximately 40g/cm2, enough to hold upside down almost any miniature with a steel sheet on its base or vice versa. In case of having neodymium magnets on the base of your miniatures, it will be necessary to choose the steel sheets as the fixing material.

The case is supplied unassembled (assembly instructions included). The steel and magnetic sheets are supplied cut to the corresponding size and not glued. Magnetic sheets have only one side magnetised. Assembly requires the use of contact or instant glue.

The methacrylate of this product is highly transparent and has a very good scratch-resistant surface quality. The MDF of this product meets the requirements of Class E1 (low formaldehyde emissions) as defined by the European Standard EN 622-1:2003.
Product Details
CMH-050-220
3 other products in the same category: